Code Error Solution Error & Solution

i10
Low fill
It is a problem with the water supply line. Something is preventing it from normal work. Check it to see what causes it. Bad water inlet valve may also be a reason for i10.

i20
Drain Line Problems / Clogged Filters
Examine a drain hose for any blocks. Also, check filters and sump. They may be clogged and need to be cleaned.

i40
Drain Line Problems / Clogged Filters
Examine a drain hose for any blocks. Also, check filters and sump. They may be clogged and need to be cleaned.

i30
Water Leak
A bottom panel is Is leaking. Check a door gasket, hose connections, and level. If you did not find a source of the leak and the error repeats, ask for professional assistance. Book online

i60
Heating Element Problem
The error is provoked by the problems with a heating element. If it became defective, it will be replaced. Plus, control the level of water in a washing machine. It should not be too low. Also check a thermal sensor, a circulation pump, and a control card for correct work.

iC0
Electronic Control System Problem
This communication error is easy to solve by simply resetting an appliance. If it fails to help, then a control board has become defective and you need to address your problem to the professional technician. Book online

UO
Vent Issue
Start with examining an air vent. If it is too dirty, clean it. This error may also be caused by a poor connection to a vent. Check the connection between a vent and control board. If it is ok, check the control board. It is highly likely that it should be replaced.

ER
Touch Pad / Key Pad Failure
This error may occur if you are pressing one button too long. The first thing to do is to reset a dishwasher. Then check the connection between a keypad and control board. If it is not an issue and the error remains, you need to replace a keypad.

CE
Communication / Configuration Error
It is either a control board problem or poor wiring. You need to check the wire connection just like in case of ER error.

dP
Drain Pump
This error will show up when the drain pump works during relay test.

RA
Rinse Aid
Start with filling a dispenser with rinse aid. If it failed to work, try checking the connection between a dispenser and control board.

PF
Power Failure
This error happens when there are any problems with the power supply.