Error codes for Whirlpool dryer that can be fixed by yourself​:

PF

This code can be shown when a power failure occurs. Push the ‘Start’ button in order to continue the cycle. Then, stop it for clearing the display. If there are repeated power failures, examine an outlet cord of the appliance.

F:02

Appears when any button is stuck on one of 2 user interface control assemblies on the console. If you cannot free the button, replace the IC with a stuck button.

F:22

This er. code shows that an open outlet thermistor is detected. Unplug the appliance. Then, check the thermistor resistance (the norm is about 10,000 ohms). If it is damaged, have it replaced.

F:23

This error shows the outlet thermistor, which is electrically shorted. To deal with the problem, unplug the appliance and then unplug the thermistor’s resistance. It should reach about 10,000 ohms. If it is damaged, have it replaced.

F:25

The system finds an inlet sensor of temperature, which is electrically shorted. Unplug the dryer. After this, check the thermistor resistance. It must be about 50,000 ohms. If the inlet thermistor is damaged, replace it. Remember: the thermistor is combined with the thermostat of the high-limit.

F:28

In this situation, unplug the appliance and examine wiring connections on the sensor. If they are all right, replace the sensor.

F:29

In this situation, unplug the dryer and examine wiring connections on the sensor. If they are all right, replace the sensor.

F:30

In this case, clean lint from the lint screen. If you apply fabric softener sheets, wash it with water and a brush in order to get rid of the fabric softener buildup. Remove any clogs from the exhaust air duct system to the outside of your home.

Error codes for Whirlpool dryer which need professional assistance:

Er:F:01

Main EC board failure

Er:F:24

Thermistor failure

Er:F:70

No communication between the EC board and the user interface control board

Er:F:72

Failure of the user interface control assembly

Er:F:78

Failure of the user interface control assembly

Er:F:71

No communication between the EC board and the user interface control board

Leave a Reply